|The MRDS support for Robotino is here! Follow the instructions below for information on using the package. Please note that the Robotino MRDS package only works with the API2 installed on Robotino.||
The RobotinoMRDS ZIP Package
- Please note that the Robotino MRDS package only works with the API2 installed on Robotino.
- Microsoft Robotics Developer Studio 4. MRDS requires .NET 4.0 but does not install it because this comes with Visual Studio.
Please note that the RobotinoMRDS package has been tested with MRDS 4. It is therefore recommended to use MRDS 4.
Download & Installation
The RobotinoMRDS ZIP package can be downloaded from the link under the Package links section on the top right of this page. After the download please go through the following steps:
- Extract the contents of the ZIP package to Microsoft Robotics Dev Studio 4\packages directory. After extraction, your directory structure should look like Microsoft Robotics Dev Studio 4\packages\RobotinoMRDS.
- Fire up the MRDS 4 DSS Command Prompt and navigate to the Microsoft Robotics Dev Studio 4\packages\RobotinoMRDS directory
- Run the script Setup.cmd
- Now run the script BuildRobotinoMRDS.cmd
- If the above mentioned steps were followed properly, then the build should complete without any errors.
Connecting to Robotino
If you would like to control your Robotino using MRDS, you will need to modify the following line in RobotinoMRDS\Services\Robotino\Robotino.cs
With the IP address your Robotino.
Note: After you make the changes, make sure you build the project once again to reflect the changes in the dll which is used by other projects within RobotinoMRDS.
The services which can be found in the RobotinoMRDS\Services directory are:
More services shall be supported in the future.
A couple of examples have been provided for a better understanding of the Robotino Services and they are located in the RobotinoMRDS\Examples directory.
The examples that have been provided are:
- DriveCircle Example
- WallFollow Example
Robotino Simulation Services
A simulated Robotino is also available for use in the Visual Simulation Environment (VSE). The simulated services which can be found under the RobotinoMRDS\Simulation\Robotino directory are:
A simulation scenario example has been provided for a better understanding of the Simulated Robotino Services and it is located in the RobotinoMRDS\Simulation\Scenarios\WallFollow directory.
The RobotinoMRDS sources
The ZIP package above contains pre-compiled dlls of the RobotinoAPI2. If you wish to stay on the bleeding edge, you may check out the sources from here. Please note the following:
The bleeding edge RobotinoMRDS sources use the environment variables ROBOTINOAPI2_32_DIR and ROBOTINOAPI2WRAPPER32_DIR to locate the required DLLs. These DLLs are built by the RobotinoAPI2 and RobotinoAPI2 Wrapper projects. Read below for more information.
Please follow the information on this wiki page to build the RobotinoAPI2 from the sources. Please do not forget to set the ROBOTINOAPI2_32_DIR environment variable.
Building RobotinoAPI2 Wrapper
Please follow the information on this wiki page to build the RobotinoAPI2 Wrapper from the sources. Please do not forget to set the ROBOTINOAPI2WRAPPER32_DIR environment variable.
The Openrobotino Forum
The Openrobotino Forum connects the developers with the users. Here you will find more support and you can also post your questions/problems/bugs etc and get a quick response.